Align the switch lamp hole with the backlight, The pins align themselves to the keyboard PBC.Check that all the switch metallic pins are perfectly straight and clean.Grab your Keyboard firmly and pull the keycap in a vertical motion.Push your Keycap Puller down until the metal hooks to open themselves and grab the keycap from underneath.Grab your Keycap Puller Tool and place it above the keycap you want to remove at a 90-degree angle.The Switch Puller tool aligns Vertically to the Switch to unclip the plastic Open the software and click Update software in the lower right corner to get Software Download : System Support: Windows After the connection is completed, start using the sottware.After the installation is complete, use the wired mode to connect to the computer, and the software will automatically recognize the keyboard.Unzip the downloaded software package and click the exe file to install.Open the official website of yunzi, click on the software. ![]() Operation for 5 minutes, and enter into deep sleep without operation for 30 When wirelessly connected (Bluetooth/2.4G), turn off the backlight without any Will light up to display the power ratio. When the backlight is turned on, press the keyĬombination Fn+Space, the backlight will turn off, and the number keys 1 to 0 When charging, the yellow light is always on Charging is complete, the green When the battery is lower than 5%, the red light flashes slowly (the backlight If the connection fails, the indicator light turn off and the keyboard sleeps.The indicator light flashes slowly during the connection process of the device, and the indicator light stays on for 2s after the connection is successful.Short press Fn+1/2/3/4/5 to switch the device connection mode.If the pairing fails, the keyboard indicator turns off and goes to sleep, please re-pair.After the pairing is completed, the indicator light will always on for 55 Find the YZ75 on the bluetooth receiving device and palred with it.After the keyboard is turned on, press and hold Fn+1/2/3 until the indicator light flashes quickly to enter pairing mode.If the code matching device is not found successfully, the indicator light turns off and goes to sleep after 60s, please perform the code matching operation again.After the code matching is successful, exit the code matching, the mode light is always on for 5s.Insert the 2.4G receiver and place the keyboard as close to the 2.4G receiver as possible.FN+ 4 until the pairing indicator flashes quickly to enter the 2.4G pairing mode.CONNECT: 2.4GHZ Wireless/Bluetooth/Wired connection.To switch between connected devices, use the appropriate key combination asįor any further assistance or support, please contact Yunzii or visit their website at ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |